UPLOAD & CREATE CUSTOM STICKER SHOE HEAT TRANSFERS
UPLOAD & CREATE CUSTOM STICKER SHOE HEAT TRANSFERS
IMPORTANT INFORMATION! (PLEASE READ BEFORE PURCHASE)
- Allow up to 1-3 days for your heat transfer to be designed and printed.
- Please enter a valid email address in your order as we may need to contact you regarding the custom image.
- Not all images are able to be printed. We will contact you if we need a better image or cannot fulfill your order. A full refund will be issued if the image cannot be fulfilled.
UPLOAD REQUIREMENTS
- Higher quality images and vectors will give best results.
- Make sure image are not too small. We will not be able to cut parts that are very fine detailed or small. A whole image would be best.
WHAT'S INCLUDED?
- 2 or 4 Pairs of Custom Shoe Heat Transfers (Each pair will contain 2 sets of images, 1 set for the left shoe and 1 set for the right shoe).
REQUIRED EQUIPMENT:
We recommend to use a mini-iron to apply the Heat Transfers. We sell a great quality Mini Iron in store.
Make sure you preheat your iron for 7-10 minutes before you begin the application of the decals.
HOW TO USE:
1. You can deglaze the shoe surface with acetone or Angelus Deglazer and Preparer.
2. Place the decal where you want it. But make sure the plastic backing is facing up, towards you. You will be applying the heat to the plastic. The decal should be looking the correct way, not mirrored.
3. Set the iron to a High heat, wait for it to heat for 5-10 minutes. Start applying heat using a mini-iron for about 10-20 seconds per area. You need to make sure you apply the heat to the side with the plastic. This will release the decal slowly from under the plastic cover onto the surface you're applying it to. Let the plastic cool a bit and then proceed to removing it, the decal will stay down on the surface of the shoes.
4. Press down with your fingers to settle it in properly, you can also apply heat from a heat gun or hair dryer after to melt it on further for a stronger hold.
5. As a last step, some choose to add a finisher such as the Angelus Matte Finisher to apply a thin layer of protection over the decals. This helps give more durability to the shoes. This does not lower the reflectiveness of the decals.
If you are unsure of how to use these, get in contact with us at info@thecustomshopp.com